Sputter Coater

Injection Screw - Injection Mold Coating

2024-07-25 2466

Surface hardness: 2000HV Coating thickness: 0.01-0.02mm Abrasion resistance: ★★★★ Corrosion resistance: ★★★★★ Anti-sticking ability: ★★★★ Applicable working conditions: high speed, high pressure, sticky material; for transparent optical products, all kinds of lenses, light guide plate, etc.; commonly used plastics for optical products: PMMA, PC, COC, COP, CR-39 and so on; reflect sth.

View Full Version

Non-precious metal coating for fuel cell bipolar plates

2023-07-29 3128

NanoShield's bipolar plate protective coating, which has entered the pilot stage, is already better than the industry average in terms of corrosion potential and ICR: Interface Resistance. The second generation of NNCL's hydrogen fuel cell coatings are still doped non-precious metal PVD coatings. We have deep cooperation with universities to maintain the industry's top level. Customized ion source and sink for fuel cell...

View Full Version

DLC diamond-like coatings

2021-09-10 6260

DLC nanocoatings are usually categorized by the ratio of sp3 to sp2 bonds and hydrogen content. Diamond is sp3 bonded and graphite is sp2. the hardness of the coating usually increases when the sp3 ratio increases. dLC coatings are sub-stable materials, and heating induces amorphous recrystallization and phase change towards sp2 graphite. DLC self-lubricating hard coatings DLC Wear Resistant Decorative Plating ...

View Full Version

Plastic molds

2020-04-14 4494

● Most of the plastic injection molded products are appearance parts, which have the most stringent requirements on the surface quality of the products, and any problems and defects on the surface of the molds will be completely reflected on the injection molded products. ● Plastic molds not only have the problem of insufficient surface hardness such as surface scratches and abrasion, but also have the problem of corrosion at the same time. Most of the wear-resistant coatings on the market are not corrosion-resistant. ● Plastic molds often have a variety of surface...

View Full Version